As you see, the right end of the browse is not at the end of the area if ::nStretchCol := STRETCHCOL_LAST
if i use ::bClrGrad to paint the header the vertlines are a different from browse and header.
I found also that SetGetColorFocus(nColor) not respected on EDIT_GET and EDIT_GET_LISTBOX!
XBROWSE Facelifting and another behavior!
XBROWSE Facelifting and another behavior!
Last edited by byte-one on Fri Dec 28, 2018 12:09 pm, edited 1 time in total.
Re: XBROWSE Facelifting
Mr. Rao, have you seen this? No good optic for me.
Re: XBROWSE Facelifting and another behavior!
I found also that SetGetColorFocus(nColor) not respected on EDIT_GET and EDIT_GET_LISTBOX!
- nageswaragunupudi
- Posts: 8017
- Joined: Sun Nov 19, 2006 5:22 am
- Location: India
- Contact:
Re: XBROWSE Facelifting and another behavior!
We need to set oCol:bClrEdit, which is by default the same as bClrStd.byte-one wrote:I found also that SetGetColorFocus(nColor) not respected on EDIT_GET and EDIT_GET_LISTBOX!
This is the behavior all these years.
Regards
G. N. Rao.
Hyderabad, India
G. N. Rao.
Hyderabad, India
- nageswaragunupudi
- Posts: 8017
- Joined: Sun Nov 19, 2006 5:22 am
- Location: India
- Contact:
Re: XBROWSE Facelifting
Please give us some more time.byte-one wrote:Mr. Rao, have you seen this? No good optic for me.
Regards
G. N. Rao.
Hyderabad, India
G. N. Rao.
Hyderabad, India
Re: XBROWSE Facelifting and another behavior!
No problem, my friend!! But the SetGetColorFocus(nColor) was functioning in the past but i dont know what version.
- nageswaragunupudi
- Posts: 8017
- Joined: Sun Nov 19, 2006 5:22 am
- Location: India
- Contact:
Re: XBROWSE Facelifting and another behavior!
Then I will check the older versions and get back to you on this.byte-one wrote:But the SetGetColorFocus(nColor) was functioning in the past but i dont know what version.
Regards
G. N. Rao.
Hyderabad, India
G. N. Rao.
Hyderabad, India
Re: XBROWSE Facelifting and another behavior!
If using code in this form, the headers, justify and sizes are not respected!
Only when i add COLS {1,2,3,4} all is functioning. But this should not required as in this case the natural order of the array should be used!
Code: Select all
REDEFINE COLUMN XBROWSE oList ARRAY aList OF oDlg ID 103 MESSAGE "Liste" ;
HEADERS {"Datum","Buchungstext","Betrag","Beleg"} ;
JUSTIFY {AL_CENTER,AL_CENTER,AL_CENTER,AL_CENTER} ;
SIZES {100,190,60}