FiveTech Software tech support forums

Antonio;

Perhaps you'd like to add these two lines right before C1: Reinaldo.

Reinaldo,

Very interesting. I wasn't aware of them. Thanks!

I have tried to add CLASS and ENDCLASS, but without success:

/Open Fold Strings = "CLASS" ...
/Close Fold Strings = "ENDCLASS" ...

Is there any special order to use ? thanks

Please also add "method" to the open fold strings.

There are various problems with "CLASS" as an open fold string. The first one is the persistence of a method "end()" which always comes before the "END CLASS". Another problem is that "CLASS" is used also in:

METHOD New() CLASS TclassName

Where it is not acting as an open fold.

If really pressed, then you could add "from" to the open fold strings. But, if you do this, you'd have to remove "method" as an open fold string as I'm suggesting above. The reason is that within the class declaration "method" is not an open fold string and would end up acting as a close fold for "from". And not all class declarations contain "from" in it.

Since the method end() is so ever present in most classes, I rather have "method" as an open fold than having "CLASS".

Just my opinion.



Reinaldo.

Sorry... I did not test before I wrote the previous post. Using "from" as an open fold will work without having to remove "method" from the list. The only problem is that not all class contain "from" in their declaration.



Reinaldo.

Reinaldo,

Are you able to fold an entire CLASS ... ENDCLASS ?

I am trying these but it does not fold the Classes (that use FROM):

/Open Fold Strings = "from" "{" "static function" "init function" "exit function" "function" "if" "while" "TRY" "for" "method"
/Close Fold Strings = "}" "return" "return nil" "endif" "endwhile" "end" "next" "return nil" "endclass"