Page 1 of 1
No selector at OVM object
Posted: Thu Jul 19, 2007 3:29 pm
by Marc Vanzegbroeck
Hello,
I have al FW195 application that works file on every PC accept for 1 client.
He get sometimes this error.
Does anyone know a solution for this?
Thanks,
Marc[/img]
Posted: Thu Jul 19, 2007 3:45 pm
by Antonio Linares
Marc,
Are you using Clipper 5.3 B ?
Posted: Thu Jul 19, 2007 7:55 pm
by Marc Vanzegbroeck
No Antonio, I'am using 5.2e
Marc
Posted: Thu Jul 19, 2007 10:12 pm
by Antonio Linares
Marc,
Try to build the application using Clipper 5.3 B
Posted: Fri Jul 20, 2007 5:06 am
by Marc Vanzegbroeck
Antonio,
I only have 5.2e. And since a couple of years, I link the vmw.obj- file, because if I remember well, this was a fix for this error.
Regards,
Marc
Posted: Fri Jul 20, 2007 7:18 am
by Antonio Linares
Marc,
Could you port your application to FWH ? Usually it takes a week or so. And its the right solution.
The error you describe is a randomly generated error almost impossible to fix. With Clipper 5.3 B you may get a better behavior.